msm8953有2路mipi，dsi0已经给了屏，dsi1用来接转换IC，现在不知道要如何配置dts，才可以使dsi1出来信号。以下是我的配置，望大神指点。
&mdss_mdp {
qcom,mdss-pref-prim-intf = "dsi";
};
&mdss_dsi {
hw-config = "dual_dsi";
};
&mdss_dsi0 {
qcom,dsi-pref-prim-pan = <&dsi_it6151_nv140fhm_edp_fhd_vid>;
pinctrl-names = "mdss_default", "mdss_sleep";
pinctrl-0 = <&mdss_dsi_active>;
pinctrl-1 = <&mdss_dsi_suspend>;
qcom,platform-reset-gpio = <&tlmm 60 0>;
qcom,platform-bklight-en-gpio = <&tlmm 63 0>;
qcom,platform-enable-gpio = <&tlmm 62 0>;
};
&mdss_dsi1 {
qcom,dsi-pref-prim-pan = <&dsi_lt9611_1080p>;
pinctrl-names = "mdss_default", "mdss_sleep";
pinctrl-0 = <&mdss_dsi_active>;
pinctrl-1 = <&mdss_dsi_suspend>;
qcom,bridge-index = ;
qcom,pluggable;
qcom,platform-reset-gpio = <&tlmm 67 0>;
};
